第1个回答 2012-05-05
First, the principle of operation
1, double-check system, the ignition condition is met, every pay-per-button remote control "light work" uniformly displayed in red;;
2, first open the cabinet door board switch "start", listen to their chirping can be the ignition device in the standby mode, direct remote control ignition or combustible gas is detected automatically when the ignition to stop firing;
, Whether automatic ignition and remote ignition, the ignition time only each time the ignition 10 seconds, automatic ignition, the combustible gas detection can be the gas before ignition, the combustible gas at the point after alarm automatically remove the ignition device is automatically reset . Such as re-detect combustible gases before automatic ignition again. Such as combustible gas has been detected, while the alarm is still in the ignition time detection of combustible gas ignition and no self-resetting, when the manual remote ignition.
.
Note: Manual remote control ignition no matter under what circumstances, operate the remote control button ignition.
4, such as remote ignition mode, simply press the remote control. "Remote ignition button" to; complete a ignition automatically stop 10 seconds after ignition, such as to be re-ignition also required; press again "remote ignition button can be re-ignition, can not even following the ignition;;
5, the entire control of battery-powered, so even without ignition, one to two months after the required battery charge times electric. .
Second, the Note
Point more than 1,10 seconds fire protection system action, auto-ignition is a normal phenomenon;
2, the entire ignition power open buzzer intermittent chirping at this time showed that the normal supply of electricity. Listen buzzer quickly tweet, it shows low battery needs charging, charging, to ensure that the ignition switch is turned on, along with the chirping sound disappeared. .
第2个回答 2012-05-04
One, principle of operation
1, carefully check the ignition system with remote control button, according to" a working indicating lamp" display the red uniform;;
2, first select the open control cabinet door switch" start", listen to its sound can be, when the ignition device in the standby state, can be directly controlled ignition, or to detect combustible gas automatic ignition, automatic stop ignition;
3, whether the automatic ignition and remote ignition, ignition time is only10 seconds each time the ignition, such as the automatic ignition, the combustible gas which can detect the gas before ignition, combustible gas in after alarm automatically eliminated, the ignition device with automatic reset. If there is a gas is again detected before again automatic ignition. As has been the detection of combustible gas, and the ignition time after the alarm is detection of combustible gas and the ignition device is not reset, then can have remote control ignition.
.
Note: the manual remote ignition whether and in what circumstances, as long as the operation of remote control button ignition.
4, as in remote ignition mode only by remote control". According to the ignition button can be completed"; once the ignition, ignition stop automatically after 10 seconds, such as the need to ignite again must; press again."" according to the ignition button can ignite again, even after ignition;;
In 5, the control uses a battery to supply power, so even if the ignition manner, one to two months of battery charging time must be electrically. .
In two, the matters needing attention
In 1, more than 10 seconds does not catch fire, protect the system action, automatic igniter is a normal phenomenon;
In 2, the ignition device in power on mode, a batch of tweets, at this time indicates that the normal power supply. When listening to a quick tweet, suggests that the low battery charge, charge to ensure the ignition switch is turned on, then chirping also disappeared. .